If you have one of these Graco battery powered swings you are probably familiar with the cost of C batteries! The swing takes four of them and they only last a handful of days. I'm not sure if the newer models support being plugged into the wall but ours didn't. If you are a little familiar with electronics and soldering, here is a rough guide on how you can modify yours to plug in! I wasn't sure how exactly to disassemble the swing side where the batteries were. I was able to open up the clamshell a bit but throughout this mod I was unable to determine how to fully separate the pieces. I suspect that there is some kind of a slip plate on the moving arm portion. The two parts of the plastic are assembled and the moving arm portion with the slip plate is slid onto the shaft. Because of the tension in that slip plate it doesn't want to back away, and because of the mechanicals that portion of the assembly doesn't appear accessible in order to free it. I was