This site was quite useful in setting up Eclipse with the cross tool chain. The one thing I missed the first time was that the compiler prefix should end in a hyphen. Since I left that off I had to manually correct some of the paths in the project configuration.
This information may apply to other cortex series processors but is written from practical experience with the Cortex-M3. Imprecise bus access faults are ambiguous, as noted by the term "imprecise". Compared to precise bus errors, imprecise errors are much trickier to debug and especially so without a deep understanding of arm processors and assembly language. Imprecise and precise flags are found in the BusFault status register, a byte in the CFSR (Configurable Fault Status Register). BusFault status register bits The definition for imprecise and precise bits is: [2] IMPRECISERR Imprecise data bus error: 0 = no imprecise data bus error 1 = a data bus error has occurred, but the return address in the stack frame is not related to the instruction that caused the error. When the processor sets this bit to 1, it does not write a fault address to the BFAR. This is an asynchronous fault. Therefore, if it is detected when the priority of the current pr
Comments
Post a Comment